Revolve

This tool allow us to generate a surface by revolving a curve around an axis.

Moving the disk will change the position of the center of creation.

Interface

Parameters

› Axis

Sets the axis to create the revolve through. The drop-down list allow to choose between:

• X: sets the X axis.
• Y: sets the Y axis.
• Z: sets the Z axis.
• Custom: it generates a custom axis by clicking two points.

› Angle to Fill

Sets the degrees of revolve angle.

› Segments

Sets the number of divisions through the revolve angle.

› Segments Along

Sets the number of divisions along the central axis.

› Cap Start

Sets the property of the start cap. The drop-down list allow to choose between:

• None: without cap.
• Polygonal: it creates a cap with triangles that matches in a central point.
• Ngon: it creates a cap with a single face, it has the same number of sides than segments.

› Cap End

Sets the property of the end cap. The drop-down list allow to choose between:

• None: without cap.
• Polygonal: it creates a cap with triangles that matches in a central point.
• Ngon: it creates a cap with a single face, it has the same number of sides than segments.

Command Validation

1. Click button to validate the command and apply the new geometry on the scene.

2. Click button to cancel the command, and refuse to apply geometry on the scene.

3. Click button to open the help information of the command, in case you need more detailed information about the tool being used.