Cone

It creates a cone where you can define the radius and the height, the segments along both, and the cap.

Dragging the handles will allow you to change dynamically the dimensions, and double-clicking to set the exact value.

Moving the disk will change the position of the center of creation.

Interface

Parameters

› Radius

Sets the radius of the cone base.

› Height

Sets the dimension along the central axis.

› Segments

Sets the number of divisions around the cone.

› Segments Z

Sets the number of divisions along the central axis.

› Cap

Sets the property of the cap. The drop-down list allow to choose between:

• None: without cap.
• Polygonal: it creates a cap with triangles that matches in a central point.
• Ngon: it creates a cap with a single face, it has the same number of sides than segments.

Command Validation

1. Click button to validate the command and apply the new geometry on the scene.

2. Click button to cancel the command, and refuse to apply geometry on the scene.

3. Click button to open the help information of the command, in case you need more detailed information about the tool being used.